I've made some further modifications to the Acktomic's genDevConfig files. One fix was to get the H.323 dial-peers to show with current versions of Cisco's IOS. I've also added some target-type code so that the various errored-second counters on the T1 interfaces in Cisco's VWIC modules can be displayed.
On the T1 controllers, the following counters are available from the 'current counter' set, and are shown as
guages:
- dsx1CurrentESs: Errored Seconds
- dsx1CurrentSESs: Severely Errored Seconds
- dsx1CurrentSEFSs: Severely Errored Framing Seconds
- dsx1CurrentUASs: Unavailable Seconds
- dsx1CurrentCSSs: Controlled Slip Seconds
- dsx1CurrentPCVs: Path Coding Violations
- dsx1CurrentLESs: Line Errored Seconds
- dsx1CurrentBESs: Bursty Errored Seconds
- dsx1CurrentDMs: Degraded Minutes
- dsx1CurrentLCVs: Line Code Violations
My earlier instructions have a section on replacing various lines. Rather than go through that
again, here are the files that need to be replaced:
Francois from Acktomic will be incorporating these changes into his version. I'll post an update when his
collection has been updated.
Here is a slightly revised command line for scanning voice gateways. There are two additional interace types
that are ignored. The line also shows how to turn on some debugging statements to see what else is performed.
/usr/share/cricket/util/genDevConfig -2 -c snmpro --vendorint --loglevel debug --voip -d 22,81,101 vgw01
2017/07/30 - Based upon FAQ: genDevConfig,
these files have been re-targeted towards www.shinken-monitoring.org. Which is interesting, as
shinkin can be used in a 'multisite' configuration with check_mk, which is my go-to for monitoring and alerting.
Github has the current genDevConfig code.